Publicidad
Idiomas disponibles
Idiomas disponibles
EN
18
INSTALLATION
• This appliance is designed to be free standing only, and should not be recessed or
built-in.
• Place your unit on a floor that is strong enough to support the unit when it is fully
loaded.
• To level your unit, adjust the leveling legs at the bottom of the unit.
• This appliance is NOT designed to be installed inside of a cabinet where the front is
covered by any type of door.
• Allow 10 cm of space between the top, back and sides of the unit, which allows the
proper air circulation to cool the compressor and condenser.
• Locate the unit away from direct sunlight and sources of heat (stove, heater,
radiator, etc.).
• Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient temperatures may also cause the unit
not to perform properly.
• Avoid locating the unit in moist areas.
• Plug the unit into an exclusive, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power
cord. Any questions concerning power and/or grounding should be directed
toward a certified electrician or an authorized Avanti Products service center.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3
hours before placing food in the APPLIANCE compartment.
Publicidad
