Franke AQCT0071 Instrucciones De Montaje Y Uso página 13

20.4 Once the LED has flashed three times, remove your hand from the range of the
sensor.
• The fitting will be switched off for 3 minutes.
• The LED flashes in a 10 second cycle.
☞
If you hold your hand around 10 cm from the sensor for at least 3 seconds, the fitting
will be reactivated before the 3 minutes has expired.
21. Maintenance and care
The fitting must be checked and maintained at regular intervals, depending on the
water quality and in accordance with the local conditions and rules and regulations
applicable at the site.
Maintain the following components:
• Shower head (see
• Filters (see
• Non-return valve (see
Use suitable cleaning agents which do not attack the fitting in a proper manner and
rinse with water after use. High-pressure cleaners must not be used for cleaning.
Removing the shower panel
For some maintenance tasks, the shower panel must be removed.
Caution!
Do not allow the shower panel to hang by the connecting hoses.
Water connection from above:
21.1 Close the water volume regulators.
a: closed
b: open
21.2 Trigger the fitting.
21.3 Disconnect the water supply.
21.4 Release the screws on the shower panel.
21.5 Unhook the shower panel.
21.6 Insert the side of the shower panel into the suspension rail.
Water connection from rear:
21.7 Release the screw on the shower panel.
21.8 Unhook the shower panel.
21.9 Insert the side of the shower panel into the suspension rail.
21.10 Close the water volume regulators (see
21.11 Trigger the fitting.
21.12 Disconnect the water supply.
Chapter 23.)
Chapter 24.)
Chapter 28.)
Work step 21.1).
- 13 -