Publicidad
Idiomas disponibles
Idiomas disponibles
IGEA
IGEA
2.2
The electrodes (applied part)
The device is set up for the generation of a specific output signal according to the dimensions of the
electrode supplied; the user should use only the electrodes provided by IGEA.
A correct therapy requires always the electrodes placed in direct
contact with the skin; they cannot be placed on any other type of material
(clothing, plaster, etc).
The materials that make up the electrode are anti-allergic and of proven
biocompatibility; the electrode can therefore be directly placed in contact
with the skin without causing any kind of problem.
To facilitate the positioning of the electrode in the seat to be treated, a
"butterfly" electrode is provided, in which the two electrodes are already
positioned at the optimal distance to perform the treatment.
3.
USE OF THE STIMULATOR
3.1
Initial charging
On receipt it is necessary to recharge the battery for about 10/12 hours before using the system,
following the instruction of chapter 4.2:
3.2
Therapy execution
After charging the battery use the stimulator as described below:
-
Insert the connector of the connection cable to the generator using the special socket marked
with "
" symbol.
-
‚ Insert the two terminal pins of the connection cable into the inlets to the butterfly electrode
-
ƒ Detach the electrode from its rigid transparent film before applying it to the treatment area.
-
Preserve this transparent film, as the electrodes may be used for up to 3-4 times before
needing to be replaced; therefore at the end of the treatment session replace the electrode on
the transparent protective film.
-
Position the adhesive part of the electrodes on the skin, making sure that the area to be treated
is between the two electrodes (in the central area of the butterfly electrode) „
OSTEOSPINE – User Manual
OSTEOSPINE – User Manual EN
19
19 19
Publicidad
