Elektra Beckum BAS 500 Instrucciones Para El Manejo página 11

Saw Table Tilt
- For bevel cuts the table can be tilted up to 45°. Loosen
the wing nut (135) of the table trunnion assembly, tilt
the table to the required position and retighten the wing
nut. Make trial cut in a piece of scrap wood to verify
setting to desired angle.
- Hand guards:
Prior to tilting the two hand guards on the underside of
the table must be moved towards the fence guide
extrusion to clear the blade when the table is tilted.
6 Safety Rules
1. Always disconnect from power when changing blades
or servicing the machine.
2. Before switching machine on be sure that all guards
are in place and securely locked.
3. Do not use cracked or bent saw blades.
4. Replace table inserts (24/79) if slot has enlarged.
5. For cutting operations with tilted table the rip fence
must be placed to the right of the blade.
6. When cutting round stock use a suitable jig to prevent
the work from turning.
7. When cutting boards in an upright position use a
suitable push block to prevent kickback.
8. Before tilting the table for bevel cuts replace the table
insert (79) with the wide slot table insert (24).
9. For safe operation and to keep dust emission within
the legal limits a dust collector with a minimum air flow
rate of 20 m/s must be connected to this band saw.
7 Additional Information
For this band saw a range of optional accessories is
available. Both the band saw and the accessories are
only to be used for operations as described in this
manual or in the instructions supplied with the
accessories. Please contact your supplier or local agent
if you require additional technical information.
8 Connection to Power Mains
This appliance is safety earthed and must be connected
to an earthed outlet. It must be operated on a residual
current device (RCD) of 30 mA capacity.
Damaged power cables must be replaced immediately
by a qualified electrician. Risk of electric shock if
operated with a damaged power cable.
Children and juveniles should not to operate this machine.
This band saw is equipped with either a 1.1 kW 220-240
V single-phase or 1.5 kW 380-415 V three-phase motor.
For connection to power mains the power cable is fitted
with an earthed plug.
All models are equipped with an electronic brake. A light
humming sound emitted from the switch for a short
period after connection to power is normal and does not
indicate a fault. If the brake fails have the fine-wire fuse
inside the switch checked. The max. permissible number
of 20 switching actuations per hour should not be
exceeded.
For three-phase machines a 5-wire electrical installation
(3 phases, neutral and earth) is required. This applies for
extension cables as well. Check for correct direction of
rotation.
The electrical installation must ensure that a dust collector
starts up when this band saw is switched on (e.g. with an
induction coil in the supply lines).
9 Optional Accessories
Crosscut and Mitre Fence
Stock-no. 090 901 8366
Circular Cutting Attachment
Stock-no. 090 901 8374
For cutting radii from 30 to 260 mm.
Belt Sanding Attachment
Stock-no. 090 900 5752
Quick and simple adaption of the belt sanding attachment
to the saw. For finishing the cut edge or deburring.
Because of the many different plastics available the
proper sanding belt speed must be found by testing.
Wheel Set
Stock-no. 090 900 0505
Fitting the wheel set to the machine makes the saw
mobile.
11