Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Operating instructions
4.3 Additional Safety Instructions
WARNING
•
Accessories must be stored and handled with care in accordance with the
manufacturer's instructions.
•
The workpiece must lay flat and be secured against slipping, e.g. using clamps.
Large workpieces must be sufficiently supported.
•
We recommend connecting a residual current circuit-breaker (FI) upstream. When
the tool is shut down via the FI circuit-breaker, it must be checked and cleaned. See
Chapter 9 for more information on cleaning the motor.
•
Damaged, eccentric or vibrating tools must not be used.
•
Disconnect the tool from the mains power supply before making any adjustments,
converting or servicing the machine.
•
A damaged or cracked handle must be replaced. Never operate a machine with a
defective handle.
•
A damaged or cracked protective cap must be replaced. Never operate a machine
with a defective protective cap.
Reducing dust exposure:
WARNING -
MontiPower
to cause cancer, birth defects or other reproductive harm. Examples of such
chemicals could include:
•
lead from lead-based paints,
•
crystalline silica from bricks and cement and other masonry products, and
•
arsenic and chromium from chemically treated lumber.
Your risk from these exposures varies depending on how often you do this type of work. To
reduce your exposure to these chemicals work in a well ventilated area, and work with
approved safety equipment, such as dust masks that are specially designed to filter out
microscopic particles.
This also applies to dust from other materials such as some timber types (like oak or beech
dust), metals and asbestos. It may also lead to allergic reactions and respiratory disease. Do
not let dust enter the body.
Observe the relevant guidelines and national regulations for your material, staff, application
and place of application (e.g. occupational health and safety regulations, disposal).
Collect the particles generated at the source and avoid deposits in the surrounding area.
Use suitable accessories for special work to ensure fewer particles enter the environment in
an uncontrolled manner.
Reduce dust exposure with the following measures:
•
do not direct the escaping particles and the exhaust air stream at yourself or nearby
persons or on dust deposits,
•
use an extraction unit and/or air purifiers,
•
ensure good ventilation of the workplace and keep clean using a vacuum cleaner as
sweeping or blowing stirs up dust.
•
vacuum or wash protective clothing. Do not blow, beat or brush.
8
– Always wear protective goggles
Depending on the surface to be treated, some dust created by the
®
®
MBX
surface preparation process may contain chemicals known
®
MBX
ULTIMATE ELECTRIC VARIOMATIC
Publicidad
