Publicidad
Idiomas disponibles
Idiomas disponibles
9.1.c - Adjusting the brush ground
contact (Fig. 13)
The machine has an adjustment system that
makes it possible to have constant contact
on the ground independently of the type and
size (thickness) of the accessories that are
used.
This adjustment is obtained by turning the
handwheel (23) located in the front part of
the machine.
If while cleaning (brushes rotating) you no-
tice that the machine does not move straight
but tends to go to the right or the left, this can
be corrected using the same handwheel (23)
with small rotations.
-
Start the machine and begin the rotation
of the brushes.
If the car tends to go to the right, gently
turn the wheel button (23) to "S" until the
direction is right;
If the car tends to go to the left, gently
rotate the wheel button (23) to "D" until
the direction is right.
9.1.d - Adjusting the front wheel (Fig.
13)
KF38BBC
(
The pressure of the brush on the floor can
be adjusted as follows, based on the type of
floor to be cleaned:
-
Turn the handwheel (56) until lifting the
wheel (22) off the ground;
-
Turn the handwheel (56) until the wheel
(22) touches the ground, then start the
machine and check while moving it that
the wheel (22) turns in the " position of
maximum brush pressure".
-
The pressure of the brush on the floor
can be reduced using the handwheel
(56) in order to slightly lift the brush; this
adjustment can be useful when cleaning
floors that are particularly porous/delicate
or antislip floors.
)
ENGLISH - 8
9.1.e - Using the machine (Fig. 14)
-
After having started the machine and se-
lected the type of cycle, start the cleaning
operation by pressing the levers (4) and
holding them pressed to start rotation of
the brush and the dispensing of water,
then push the machine by means of the
handles (54) in the handle bar (1).
NOTE:
Releasing the levers (4) stops the rotation of
the brush and the dispensing of water.
NOTE:
To avoid damaging the floor, do not use the
machine in a fixed position with brush rota-
tion activated
NOTE:
The correct way of cleaning and drying the
floor is to move the machine forwards. Mov-
ing the machine backwards damages the
blades as well as not allowing correct aspira-
tion of the water present on the floor.
-
If necessary, adjust the quantity of wash-
ing water using the tap (55).
-
Check the status of the battery charge by
the indicator (24) (KF38BBC).
9.1.f - End of use and switching off
(Fig. 1)
-
At the end of the cleaning operation and
before turning off the machine, stop the
dispensing of water and the rotation of
the brush by releasing levers (4) and
pressing the button (27) to continue with
the aspirator to remove all of the liquid
present on the floor, and then turn off the
aspirator by pressing button (25).
-
Lift the floor wiper (14) by pressing the
pedal (3) to the end stop, engaging it in
its slot.
Publicidad
