Metabo TBP 6200/8 Inox Manual Original página 11

The pump runs very noisily
• Pump is sucking air.
- Ensure that there is an adequate supply of
water.
10. Accessories
Use only genuine Metabo accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
See www.metabo.com or the catalogue for a
complete range of accessories.
11. Repairs
Danger! Repairs to this pump must only be
carried out by qualified electricians!
If the mains connection cable of this pump is
damaged, it must be replaced by the manufacturer
or an authorized service centre to avoid hazard.
Contact your local Metabo representative if you
have Metabo pumps requiring repairs. For
addresses see www.metabo.com.
For shipping: Empty the pump completely.
You can download a list of spare parts from
www.metabo.com.
12. Environmental Protection
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
pumps, packaging and accessories.
Packaging materials must be disposed of according
to their labelling in accordance with municipal
guidelines. Further information can be found at
www.metabo.com in the "Service" section.
Only for EU countries: never dispose of
power tools in your household waste!
According to European Directive 2012/19/EU
on Waste from Electric and Electronic Equipment
and implementation in national law, used power
tools must be collected separately and recycled in
an environmentally-friendly manner.
13. Technical Specifications
Explanatory notes regarding the specifications on
page 3.
Subject to change in accordance with technical
progress.
The pump characteristic curve (diagram on page 3)
shows the conveying capacity that can be reached
depending on the conveying height (suction hose
diameter = pressure connection diameter).
U = Mains voltage
f = Frequency
P = Rated input power
1
I = Rated power
F = Fuse min.
L = Length of the mains connection cable
F = Max. conveying capacity
V,max
F = Max. conveying height
h,max
F = Max. conveying pressure
p,max
H = Minimum submersion depth / minimum
min
delivery head
T = Max. submersion depth
max
= Max. supply temperature
temp
= Protection type
1
S = Protection class
2
D = Pressure connection female thread
p
A = Dimensions:
Height x diameter (without stand / with
stand)
L = Impellers
m = Weight (with mains cable)
1
m = Weight (without mains cable)
2
K = Maximum length for extension cable with
1
2
3 x 1.0 mm
K = Maximum length for extension cable with
2
2
3 x 1.5 mm
~
AC power
The technical specifications quoted are subject to
tolerances (in compliance with relevant valid
standards).
ENGLISH en
wire cross-section
wire cross-section
11