Publicidad
Idiomas disponibles
Idiomas disponibles
Elbow
Tube
Small
Opening
,,,
Zipper
Opening
Rib
NOTE:
Make sure edge ofthe small opening
is flush against
the flared area of the elbow
tube. and the rib on the elbow tube is on the
bottom.
3. Closethe
zipper on the bag. Make sure the
zipper is closed
completely.
4. Remove
blower tube from engine.
roove
5. Insert the elbow tube into the blower outlet.
Make sure elbow tube
rib is aligned
with
the blower
outlet groove.
6. Turn knob clockwise
to secure elbow tube.
VACUUM
TUBE
ASSEMBLY
WARNING:
Stop enghse and be sure
the impeller blades
have stopped
turning be-
fore
opening
the vacuum
inlet door or at-
tempting
to insert
or remove the vacuum
or
blower
tubes. The rotating blades can cause
serious
injury.
1. Align the lower vacuum
tube
as shown.
Push tower vacuum tube into upper vacu-
um tube.
Lower Vacuum
Tube
2. Insert the tip of a screwdriver
into the latch
area of the vacuum
inlet.
L__
_
Blower
Outlet
Latch Area
Vacuum
Inlet Cover
3. Gently tilt the handle of the screwdriver
to-
ward the back
of the unit to release
the
latch while pulling up on the vacuum
inlet
cover with your other hand.
4. Hold the vacuum
inlet cover open until up-
per vacuum tube is installed.
Vacuum
inlet
Retaining
Post
Xl_,,_
!
;if_
5. Place the hooks of the upper vacuum tube
on the retaining posts of the unit.
6. Pivot the tube
until it is secured
to the
blower unit by the vacuum
inlet latch.
PIVOT
inlet Cover
Latch
Hook
Post
HOW
TO CONVERT
UNIT
FROM
VACUUM
USE
TO BLOWER
USE
1. Remove
the vacuum
tubes
by inserting
the tip of a screwdriver
into the latch area
of the vacuum
inlet.
2. Gently
tilt handle of screwdriver
toward
the back
of the unit to release
the latch
while pulling up on the upper vacuum tube
with your other hand.
Latch Area
,E_
3. Remove the vacuum
bag.
4. Close the vacuum
inlet cover
and make
sure it is latched closed.
5. Reinstall the blower tube
(see BLOWER
TUBE ASSEMBLY).
-4-
Publicidad
