Descargar Imprimir esta página

Avanti SED70D0W Manual De Instrucciones página 23

Publicidad

Idiomas disponibles

Idiomas disponibles

CONNECT THE GAS LINE (FOR GAS MODELS)
Review the "Gas Requirements" section on page 14. Remove the pipe
thread protective cap.
Apply a pipe joint compound or about 1
threaded connections.
The pipe joint compound must be resistant to the actions of any
liquefied petroleum gas.
Connect the gas supply to your dryer. An additional fitting is required
to connect the
3/8
the
" (1 cm) male threaded end on the dryer. Use only new AGA or CSA
certified gas supply line with SS flexible connectors within 6 ft (1.8 m) of
the dryer.
Securely tighten the gas line fitting over the threads.
Turn on the gas supply.
WARNING
All gas installations of the dryer must be equipped with Manual Shut-
Off valve.
Uncoated copper tubing will corrode when subjected to natural gas,
causing gas leaks. Use ONLY black iron, stainless steel, or plastic-
coated brass piping for gas supply.
Check all gas connections for leaks using a soap solution.
If bubbles appear, tighten the connections and recheck. DO NOT use
an open flame to check for gas leaks.
23
3/4
" (1.9 cm) female thread end of a flexible connector to
Manual
Flare
Shutoff
Union
Valve
Nipple
Open
All connections must be wrench-tightened
" wraps of teflon tape over all
1/2
GAS FLOW
Flexible
Connector
Flare
Union
Inlet Pipe on
Back of Dryer

Publicidad

loading

Este manual también es adecuado para:

Sgd70d0wg