Publicidad
Idiomas disponibles
Idiomas disponibles
Check motor safety filter frequently.
If the motor safety filter, located in the bottom of
the dust bag cavity is dirty, remove it by pulling
forward out from under the ribs.
Filter
Wash the foam filter in warm soapy water.
Rinse and dry thoroughly by squeezing the filter
in your hand and letting it air dry.
DO NOT wash filter in the dishwasher.
DO NOT install damp filter.
Replace the foam filter by sliding it back into
place under the ribs in the dust bag cavity.
WARNING
Electric Shock Hazard
Do not operate the cleaner without
the motor safety filter. Be sure the
filter is dry and properly installed to
prevent motor failure and/or electric
shock.
Always unplug power cord from
electrical outlet before performing
any service on vacuum.
WARNING
Do not operate without exhaust filter.
Clean the exhaust filter when it becomes dirty,
or replace it with a new one. Wash the dirty
filter beneath cold, running water to clean it.
Allow to air dry before returning it to the
vacuum.
Do not attempt to clean the filter with a brush.
A brush will permanently damage the filter,
causing dust to blow back into the room when
you are vacuuming.
If you use vacuum frequently, you should
replace the filter every 6 months.
Check filter frequently.
/_
Dust_
Cover
1
Pull the dust cover forward. Remove and lay
aside.
Remove the exhaust filter by pulling it out.
Replace the filter so that the gray side faces
out.
Carefully replace the dust cover by placing tabs
in slots and pushing in until cover snaps into
place.
-13-
Publicidad
