SpeedEPart Agri-Fab 45-0472 Manual Del Usuario página 6

oPeration
Become familiar with all of the controls and adjustments
on the Electric Dethatcher before operating. Controls for
operating Electric Dethatcher are as follows:
saFety switCh - Must be pressed in before handle
switch can be used to start motor.
handle switCh - Pull and hold to start and keep
motor running. When let go motor will stop and safety
switch should re-engage.
Power Cord - Supplies electricity to the
Electric Dethatcher, make sure to connect to a power
supply using only outdoor rated extension cables.
Cord holder - Holds extension cord to help keep it
out of the way and take stress off of the handle switch
cord.
extension Cord ratings
(use only outdoor rated extension cords plugged into a
ground fault receptacle.)
gauge
16 Gauge
14 Gauge
SAFETY
SWITCH
POWER
CORD
CORD
HOLDER
Figure 7
length
0 - 50 Feet
51 - 100 Feet
CORD
HOLDER
HANDLE
SWITCH
EXTENSION
CORD
maintenanCe
Caution:
any maintenanCe, make sure the
eleCtriC dethatCher is turned
oFF and unPlugged From any
Power sourCe.
• Clear excess debris left in Electric Dethatcher
housing after each use.
• Make sure nothing has wrapped around the tines/
tine shaft. Remove anything that has wrapped itself
around the tines/tine shaft.
• Check and make sure all wing knobs and carriage
bolts are tightened. Re-tighten any loose knobs and
bolts.
storage
• Clean Electric Dethatcher and bag before storing.
not clean with water, solvents or petroleum based
products.
• Store in a dry place that is not exposed to the
elements and out of the reach of children.
6
BeFore PerForming
do