Beta 599DGT Instrucciones página 17

MAINTENANCE AND STORAGE
ATTENTION:
It is recommended that the wrench be checked for calibration after 12 months' operation or
after 5,000 cycles.
Please contact your local dealer for calibrations (UNI EN 26789 - ISO 6789)
ATTENTION:
1. Over-torque (105% of max. torque range) could cause breakage or lose accuracy.
2. Do not shake violently or drop wrench.
3. Do not use this wrench as a hammer.
4. Do not leave this wrench in any place exposed to excessive heat, humidity or direct sunlight.
5. Do not use this apparatus in water (it is not waterproof).
6. If the wrench gets wet, wipe it with a dry cloth. The salt in seawater can be especially damaging.
7. Do not use any organic solvents, such as alcohol or paint thinner, when cleaning the wrench.
8. Keep this wrench away from magnets.
9. Do not expose this wrench to dust or sand, as this could cause serious damage.
10. Do not apply any force to the LCD panel.
BATTERY MAINTENANCE
1. When the Beta 599 DGT wrench is not used for an extended period of time, remove the battery.
2. Keep a spare battery on hand when going on a long trip or to cold areas.
3. Do not mix battery types or combine used batteries with new ones.
4. Sweat, oil and water can prevent a battery's terminal from making electrical contact. To avoid this,
wipe both terminals before loading a battery.
5. Dispose of batteries in a designated disposal area. Do not throw batteries into a fire.
EC Declaration of Conformity:
The product complies with the requirements of Directive 2004/108/EC (EMC).
Conformity is declared in accordance with EN 61000- 6-2 / EN 55011.
17