Publicidad
Idiomas disponibles
Idiomas disponibles
B
C
B
D
A. Mounting screws
B. 4 screws - 4.2 x 19 mm
C. 2 D5.3 x 20 mm washers
D. 2 screws - 6 x 80 mm
4
Install 4 - 4.2 x 19 mm screws through the back of the
hood into the wood support and tighten.
5
Connect vent system to hood. Seal all joints with clamps.
Install Transition
•
Install the 10" (25.4 cm) square x 10" (25.4 cm) round
vent transition with damper to top or rear side of the
range hood (depending on your installation), using
4 - 3.5 x 9.5 mm screws.
NOTE: The exhaust adaptor/damper can be installed up to 1
inch on either side of the hood center to accommodate offcen-
ter ductwork. In extreme offcenter installations, one end of the
duct connector may need to be trimmed to clear the electrical
cable clamp.
Install Range Hood Internal Blower Motor
1
Remove grease filters from range hood. See the
"Maintenance" section in the Use and Care Guide.
2
Install the range hood blower motor assembly inside the
range hood canopy with the wiring connection to the left
for the single motor system and to the front or top for the
dual motor system.
10
A
A. Wiring connection
A. Wiring connection
3
Slide the left mounting plate flange under the motor
mounting bracket.
4
Run the power supply wires and connector from the ran-
ge hood through the hole in the right end of the motor
mounting plate.
5
Push the right end of the motor mounting plate up and
snap it into the spring tab.
NOTE: The spring tab should be outside the slot in the
mounting plate.
6
Align mounting holes and install 6 x 16 mm screws and
6.4 mm lock washers
Single blower motor assembly
A
Dual blower motor assembly
B
A
A. Motor mounting plate hole
B. Power supply wires and connector
A
A. Motor mounting bracket
B. Mounting plate left flange
A
B
Publicidad
