Publicidad
Idiomas disponibles
Idiomas disponibles
B
A. Screw with lock washer
B. Mounting hole
7
Attach power supply connector from the range hood to
the connector on the blower motor assembly wiring box.
A
B
A. 4- 4x8 mm mounting screws
B. Security screws
8.
Place the grease fittings in the hood.
A
9. Fasten the grease fitting bracket with the screws provided
C
B
B. Drip tray bracket
C. Drip tray bracket screws (2
10. Reinstall the filters in place.
A
A. Drip tray
A
A. Drip tray
ELECTRICAL CONNECTION
I WARNING
ELECTRICAL SHOCK HAZARD.
DISCONNECT POWER BEFORE SERVICING.REPLACE ALL
PARTS AND PANELS BEFORE OPERATING. FAILURE TO DO
SO CAN RESULT IN DEATH OR ELECTRICAL SHOCK.
•
Remove the knockout and the Junction box cover and
install the conduit connector (cULus listed) in junction box.
A
B
C
D
A. White wires
B. Black wires
C. UL listed wire connector
•
Run 3 wires; black, white and green ,according to the
National Electrical Code and local codes and ordinances,
in
1
⁄
" conduit from service panel to junction box.
2
I WARNING
ELECTRICALLY GROUND BLOWER. CONNECT GROUND WIRE
TO GREEN AND YELLOW GROUND WIRE IN TERMINAL BOX.
FAILURE TO DO SO CAN RESULT IN DEATH OR ELECTRICAL
SHOCK.
•
Connect black wire from service panel to black or red in
junction box, white to white and green to green-yellow.
•
Close and secure junction box cover.
CFM Reduction harness instalation
(OPTIONAL)
Hood
B
C
D
1
Disconnect power
2
Remove the metal grease filters from the bottom panel.
3
Disconnect motor harness.
4
Connect extension end (B) with hood harness (A).
5
Connect extension end (C) with motor connection (D).
6
Install the metal grease filters.
7
Reconnect the power.
E
F
D. Green (or bare) and yellow-green
ground wire
E. Home power supply cable
F. UL listed or CSA approved ½" strain relief
A
CFM Kit
Reduction
A. Hood harness
B. Extension end B
C. Extension end C
D. Motor connection
11
Publicidad
