Braun Skin i-expert 6036 Manual Del Usuario página 19

Sensitive Mode
Push the mode button (4) to reduce the light intensity. You can toggle through the following 3 settings:
Standard: 3 indicator lights
Sensitive: 2 indicator lights
Extra Sensitive: 1 indicator light (lowest light intensity with fast flash rate)
Sensitive and extra sensitive settings are intended for sensitive areas and first time users. With reduced
light intensity, more treatments may be required to see the desired effects.
The power bars flash to confirm a change in the light intensity setting.
When holding the mode button (4) longer than 3 seconds, the device is deactivated.
After 10 minutes without use, the device is automatically deactivated.
Press any button to re-activate it.
Skin Test
Before your first treatment, we recommend you test your skin for reaction on a small area of skin on one of
the following body parts: lower leg, upper leg, arm pit, lower arm.
Perform two flashes next to each other as described below in chapter «Treatment methods»,
section «STAMPING». Wait 15 minutes to examine the test area. If the skin appears normal, begin your first
treatment. If a skin reaction develops, switch to sensitive mode and repeat the test. Wait for another 15
minutes. If the skin reaction persists, wait for another 24 hours. If skin reaction is present after this period,
discontinue using the device and consult your physician.
Treatment methods
The area to be treated must be hair-free, clean and dry. Before pushing the treatment button, look away
from the device to avoid the bright light. In seldom cases, a user may find the flash too bright. However,
there is no safety risk associated with this. For increased comfort, we recommend treating in a well-lit
room to help reduce the perceived brightness.
GLIDING
for fast and efficient
treatment of large areas
(e.g. legs).
1. Place the treatment window firmly on your skin, ensuring both skin sensors have skin contact.
The power bars (3) show white LEDs
2. Press and hold the treatment button (5). The
device will begin to flash.
3. Move the device slowly and continuously from
the bottom to the top of the treatment area.
Make sure to always keep full skin contact so
that the device flashes continuously.
Once the gliding stroke is completed, lift the
device off the treatment area. Repeat steps 1-3 to
treat the next adjacent area in a parallel stroke.
light skin tone ➞ high light intensity
dark skin tone ➞ low light intensity with fast flash rate
no skin contact ➞ device will not flash
no LEDs
invalid skin tone ➞ device will not flash
red LED
STAMPING
for treating small,
hard-to reach areas
(e.g. face / public area
for females, underarms,
knee, chin, ankles)
2. Press and instantly release the treatment
button (5). The device will emit a flash.
3. Lift off the device and place it onto the next
adjacent spot to be treated. Wait for the power
bars to show white LEDs. Then press and
release the treatment button.
Continue treatment spot by spot until you have
completed the entire area you wish to treat.
19