Publicidad
Idiomas disponibles
Idiomas disponibles
Assembling Remaining Bagger Components
Now that the mounting brackets are assembled and are in place on
the tractor, follow these steps to assemble the remaining bagger
components.
1.
Snap the upper chute support in place by first clipping the side
portion onto the bin support rail. Align the edge of the snap
feature with the red line (1), as shown in the inset of Fig. 13.
2.
Snap the front portion of the upper chute support to the bin
support rail as seen in 2 of Fig. 13.
2
3.
Install the grass catcher cover screen into the bagger cover by
first inserting the end closest to the side with the cutout into the
mounting hole, as in Fig. 14. Make sure to feed the screen under
the lip, as in Fig. 15.
4.
Clip in the other side by flexing the screen and pushing it down
into the provided cutout hole. See Fig. 15.
ASSEMBLY AnD InSTALLATIOn
Figure 13
Figure 14
1
Make sure screen sits
under the cover's lip
5.
Install the grass catcher cover onto the bin support assembly, as
seen in Fig. 16. The grass catcher cover goes inside of the two
mounting tabs on the bin support assembly.
6.
Slide the hinge pin into the hole located on the mounting tab, as in
Fig. 17 on the following page. Use the cut-out window (See inset
in Fig. 17) to line up the hinge pin on the other side and push pin
all the way in until it reaches the end-stop. At this point the pin
clips into place and is secured by a tab in the bagger cover. See
Fig. 18.
11
Figure 15
Figure 16
Publicidad
