Publicidad
Idiomas disponibles
Idiomas disponibles
Shutting Off the Trimmer
To shut off the trimmer, release the trigger.
Whenever you are not using the trimmer or are
transporting the trimmer to or from the work area,
remove the battery pack.
Removing the Battery Pack
from the Power Head
Press the battery latch on the machine to release the
battery pack and slide the battery pack out of the
machine
(Figure
8).
1. Battery latch
Removing the Attachment
from the Power Head
1.
Ensure that the battery pack is removed from
the power head; refer to
Pack from the Power Head (page
2.
Loosen the screw-handle on the shaft connector
(Figure
3).
3.
Press the locking button down while pulling the
2 shafts apart
(Figure
Figure 8
Removing the Battery
10).
3).
Advancing the Line Using
the Bump Feed
1.
Run the trimmer at full throttle.
2.
Tap the bump button on the ground to advance
the line. The line advances each time the bump
button is tapped. Do not hold the bump button
on the ground.
Note:
The line trimming cut-off blade on the
grass deflector cuts the line to the correct length.
Note:
If the line is worn too short, you may not
be able to advance the line by tapping it on the
ground. If so, release the trigger and refer to
Advancing the Line Manually (page
1. Bump button
g357457
Advancing the Line
Manually
Remove the battery pack from the trimmer, then push
the bump button at the base of the spool retainer
while pulling on the trimmer line to manually advance
the line.
10
10).
Figure 9
g331007
Publicidad
