Publicidad
Idiomas disponibles
Idiomas disponibles
Immediately
prepare your tiller for storage
at the end of the season or if the unit will
not be used for 30 days or more,
_&Warning:
Never store the tiller with gas-
oline in the tank inside a building where
fumes may reach an open flame or spark.
Allow the engine to cool before storing in
any enclosure.
TILLER
1. Clean
entire
tiller
(See "CLEANING"
in
the Maintenance
section
of this man-
ual).
2.
Inspect
and replace
belts,
if necessary
(See belt replacement
instructions
in
the Service
and Adjustments
section
of
this manual).
3.
Lubricate
as shown
in the Maintenance
section
of this manual.
4.
Be sure that all nuts, bolts and screws
are securely
fastened.
Inspect
moving
parts for damage,
breakage
and wear.
Replace
if necessary.
5.
Touch
up all rusted
or chipped
paint
surfaces;
sand
lightly
before
painting.
ENGINE
FUEL SYSTEM
IMPORTANT:
It is important to prevent
gum deposits from forming in essential
fuel system parts such as the carburetor,
fuel filter, fuel hose, or tank during stor-
age. Also, alcohol blended fuels (called
gasohol or using ethanol or methanol)
can
attract moisture which leads to separation
and formation of acids during storage.
Acidic gas can damage the fuel system of
an engine while in storage.
• Empty the fuel tank by starting the en-
gine and letting it run until the fuel lines
and carburetor
are empty.
• Never use engine or carburetor cleaner
products in the fuel tank or permanent
damage may occur.
• Use fresh fuel next season.
NOTE:
Fuel stabilizer
is an acceptable
alternative
in minimizing
the formation
of
fuel gum deposits
during
storage.
Add
stabilizer
to gasoline
in fuel tank or stor-
age container.
Always
follow
the mix ratio
found
on stabilizer
container.
Run engine
at least 10 minutes
after adding
stabilizer
to allow
the stabilizer
to reach the carbu-
retor.
Do not empty
the gas tank and
carburetor
if using fuel stabilizer.
ENGINE
OiL
Drain oil (with engine warm) and replace
with clean oil, (See "ENGINE" in the
Maintenance
section of this manual).
CYLINDER
1.
Remove
spark
plug.
2.
Pour 1 ounce
(29 ml) of oil through
spark
plug hole into cylinder.
3.
Pull starter
handle
slowly
several
times
to distribute
oil.
4.
Replace
with new spark
plug.
OTHER
• Do not store gasoline
from one season
to another.
• Replace
your gasoline
can if your can
starts to rust.
Rust and/or
dirt in your
gasoline
will cause
problems.
• If possible,
store your unit indoors
and
cover
it to give protection
from dust and
dirt.
• Cover
your unit with a suitable
protec-
tive cover that does not retain
moisture.
Do not use plastic.
Plastic
cannot
breathe
which
allows
condensation
to
form
and will cause
your unit to rust.
IMPORTANT:
Never
cover tiller while
en-
gine and exhaust
areas
are still warm.
17
Publicidad
