Hilti PC 2-22 Manual De Instrucciones Original página 17

1. Remove the spray nozzle from the spray lance.
2. Insert the pointed object into the spray nozzle.
3. Move the pointed object back and forth until it moves easily.
4. Install the spray nozzle on the spray lance.
8 Transport and storage of cordless tools and batteries
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery/batteries.
▶ Never transport batteries loose and unprotected. During transport, batteries should be protected from
excessive shock and vibration and isolated from any conductive materials or other batteries that may
come in contact with the terminals and cause a short circuit. Comply with the locally applicable
regulations for transporting batteries.
▶ Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶ Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9 Troubleshooting
If a problem occurs, always observe the status indicator of the battery. See the section headed Status
indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, contact Hilti Service.
9.1 Troubleshooting table and tips for assistance
Trouble or fault
LEDs of the battery show
nothing
Motor does not start
Motor is running but no pres-
sure built up
Pulsating pressure
*2404923*
Possible cause
Battery faulty.
Frozen up
Spray nozzle clogged
Air in hose or pump
2404923
Action to be taken
▶ Contact Hilti Service.
▶ Allow pump, hose or accessory
to thaw out.
▶ Clean the spray nozzle.
▶ Run the high-pressure cleaner
with water faucet open until
a steady working pressure is
achieved.
English 11