Publicidad
Idiomas disponibles
Idiomas disponibles
REMOVING
BITS
(Fig. 7)
1.
Remove the battery
pack from the impact
driver when removing the bit.
2.
Lock the trigger switch on the impact driver by placing the direction-of-
rotation (forward/center-locWreverse)
selector
in the center position.
3.
Pull the coupler away from the driver.
4.
Remove the driver bit from the coupler..
WARNING:
Use protective
gloves when removing
the bit from the tool, or
first allow the bit to cool down. The bit may be hot after prolonged
use.
_,
CAUTION:
The impact driver is not designed
to be used as a drill.
TIGHTENING
AND
LOOSENING
SCREWS
AND
NUTS
(Fig. 8)
1.
Install the correct
bit.
2.
Place the direction-of-rotation
(forward/center-lock/reverse)
selector
in the correct
position
for the operation.
3.
Apply just enough pressure to
keep the bit engaged
on the
screw or nut.
Fig. 8
4.
Apply minimal
pressure to the
trigger switch
initially. Increase the speed only when full control can
be maintained.
,_
WARNING:
Do not over-tighten,
as the force of the impact driver can break
the fastener.
Keep the driver at a right angle to the fastener to avoid damaging
the fastener
head.
14
Publicidad
