Publicidad
Idiomas disponibles
Idiomas disponibles
4. ADJUSTING HEADGEAR (FOUR PARTS)
4.1. Headgear top (see adjustment "W" in the fig. 4)
Pressing the adjusting knob located on the back of the headgear and turn left or right to a desired tightness.
4.3 Headgear tightness (see adjustment "Y" in the fig. 4)
Adjusting the distance between the face and the lens by loosening both outside tension knobs and press inward to
free from adjustment slots. Move forward or back to desired position and retighten. (Both sides must be equally
positioned for proper vision.)
4.4 Angle adjustment (see adjustment "X" in the fig. 4) Four pins on the right side of the headgear top provide adjustment
for the forward tilt of the helmet. To adjust, loosen the right outside tension adjustment knob then lift on the control
arm tab and move it to the desired position and retighten tension adjustment knob.
5. AUTO-DARKENING FILTER FUNCTIONS
5.1 Selecting the Operating Mode
For some filters, two modes of operation can be selected: welding or grinding. (See Fig.3)
Grind
Mode: shade function is turned off. In this mode the shade is fixed in the light state that allowing a clear view to
grind a weld with the helmet providing face protection. Used for metal grinding applications.
Grind mode is intended for Grinding not for welding. Before restarting welding, the knob should be set back to the " Weld
position".
Weld Mode-Used for most welding applications. In this mode the shade function is turned on. When it optically senses a
welding arc, please select a suitable shade level,delay time and sensitivity as required.
KEEP WORKiNG
KEEP WORKiNG
Keep Working
Fig3
03
C S v M
7 6 0
Fig4
Publicidad
