Publicidad
Idiomas disponibles
Idiomas disponibles
5.2 Selecting Delay Time
The Delay Time knob will vary from dark to light time,it can be set at MAX (1.0 second) or MIN (0.1second) by using the
infinitely dial knob.(See Fig.6)
MAX 1.0 second-Longer delay is for most welding applications, specially for high amperage (current) applications.
MIN (0.1 s ec ond)-Shorter delay is for Spot welding applications
Longer delay can also be used for TIG Welding in order to prevent the filter opening when the light path to the sensors is
temporarily obstructed by a hand, torch, etc.
5.3 Selecting Sensitivity
The sensitivity can be set at "HI"(High) or "LO"(Low) by using the infinitely dial knob. (See Fig.7)
As a simple rule for optimum performance, it is recommended to set sensitivity at the High at the beginning and then
gradually reduce it, until the filter reacts only to the welding light flashes and without annoying spurious triggering due to
ambient light conditions (direct sun, intensive artificial light, neighboring welder 's arcs etc.)
"HI" (High)- Most for welding applications but specially for low welding current work.
"LO" (L ow)- Only in some specific surrounding lighting conditions in order to avoid unwanted triggering.
5.4 Power
All the welding helmets are powered by solar energy. Some of models are without replaceable batteries. Some selected
models need to replace Li-Batteries when LOW BATTERY Light starts blinking.
KEEP WORKiNG
KEEP WORKiNG
Keep Working
Fig6
04
C S v M
7 6 0
Fig7
Publicidad
