6.1. 2 Pair the Cameras with The NVR
NOTE:
The battery camera has been paired with the NVR, no code pairing is
required. But if the pairing information between the camera and NVR is
cleared, you need to re-pair the code, and follow the steps below:
(1) Place the camera near the NVR at a distance of 30~100cm.
(2) In the power-on state, press and hold the reset button of the camera for 3-5
seconds, after hearing a voice prompt from the camera, open the NVR system
interface and use the camera to scan the QR code (Phone port number) for
pairing. After that, the camera will give out a voice prompt to indicate that
pairing success.
8