Descargar Imprimir esta página

Kenmore 116.35912 Manual Del Propietário página 16

Publicidad

Idiomas disponibles

Idiomas disponibles

TO REPLACE DUST BIN LID
Replace dust bin lid assembly by placing
back on dust bin with marks on the lid
aligned as shown under Open (For
EmpO#ng ) on the back of the dust bin.
Turn This Dire€lion
To Close For Use
Open
(For Emptying)
Closed
(For Use)
Rotate clockwise while pressing downward
so marks align as shown above C/osed
(For Use),
Insert dust bin
into cleaner.
Lower the dust
bin handle to
lock dust bin in Handle
place.
A noticeable
"click" should
be heard.
ElectricalShock Hazard
Unplug power cord from electrical out-
let. Do not operate the vacuum clean-
er withoutthe motor safety filter. Be
sure the filter is dry and properly
ir_-talledto prevent motor failure and/or
electrical shock.
MOTOR SAFETY FILTER
Check motor safety filter frequently and clean
when dirty.
I
S.
/
<
Release
Handle
1, To remove motor safety filter lift filter
release handle upward and rotate the filter
cover out,
2. Remove filter by pressing on the sides of
the filter frame and pulling out at the same
time.
Frame
Cover
Tabs
3. Clean filter if necessary by placing it under
running water wait until dry before replacing.
4. When putting the filter back into the filter
cover, listen for the filter assembly to snap
into place.
Note: Push only on frame, not filter itself.
5. Replace cover by fitting bottom tabs into
slots and rotating into compartment. Push
filter release handle down until you hear a
noticeable "click",
16

Publicidad

loading

Este manual también es adecuado para:

116.35913