Kenmore 116.35912 Manual Del Propietário página 18

Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
performing maintenance to the unit.
Failure to do so could result in
electrical shock or personal injury
from the vacuum cleaner suddenly
starting.
TO REMOVE LIGHT BULB
1. Disconnect power cord from electrical
outlet.
Rat
Screwdriver
Headlight
Lens
2. Press han-
dle release
pedal and lay
vacuum clean-
er back.
3. Pry light
lens out at slot
in rear as
shown on both
sides. Rotate
lens up and lift
off.
CAUTION
Do not use a bulb rated over 9W (13V).
During extended use, heat from the bulb
could overheat surroundingplastic
parts.
4. Remove the light
bulb by pulling
straight out.
5. TO replace the
light bulb carefully
insert fully into slot.
Note: See PARTS AND FEATURES for
bulb number.
!
CAUTION
Do not plug in or turn on untilthe vacu-
um cleaner is completely reassem.
bled.
6. To replace light
lens, place tab at
front of lens into
slot. Rotate lens
down and firmly
snap into place.
18