GE 21 Serie Manual Del Propietario Y Instalación página 4

About the controls with temperaturesettings.
(on some models)
[]
[]
TEMPERATURE SET
WARMER _ _WARMER
COLDER COLDER
0 o F Recommencled 37 - F Recommended
[]
[] []
Hold 3 seconds to _eset NoEd 3 seconds
(on some models)
NOTE: Therefrigerator is shipped with protective film covering the temperaturecontrols.
If this film was not removedduring installation, remove it now
The temperature controls are preset in the factory at 37°F for the refrigerator compartment
and O°F for the freezer compartment. Allow 24 hours for the temperature to stabilize to the
preset recommended settings.
The temperature controls can display both the SET temperature as well as the actual
temperature in the refrigerator and freezer. The actual temperature may vary slightly from
the SET temperature based on usage and operating environment.
Setting either or both controls to OFF stops cooling in both the freezer and refrigerator
compartments, but does not shut off electrical power to the refrigerator.
4
Changing the Temperature
For Controls-on-the-DoorModels:
To change the temperature,
press and release the
WARMER or COLDER
pad.
The ACTUAL
TEMPlight
will c(nne on and the display will show the actual
temi)eratm'e. To change the temperature, tap
either the
WARMERor COLDER
pad tmtil the
desired temperature is displayed.
For ControlsInside the Refrigerator:
Opening the door displa):s the actual temperature.
To change the temperature, press either the
WARMER or COLDER touch pads tmtil the
desired temperature is displayed.
Once the desired temperature has been set,
the temperatm'e display will return to the actual
i'efi-Jgei'ator and fl'eezer teil/perattlres aftei" .5
seconds. Several ac!iustments
may be required.
Each time )ou ac!iust controls, allow 24 horns fin" the
refrigerator to reach the temperature you haxe set.
To turn the
cooling
system off, trip the WARMER pad
fro" either the refl_igerator or the fl'eezer tmtil the
display shows
OFF. To turn the unit back on, press
the
COLDER pad
for either the refl_igerator or fl'eeze_:
Then press the COLDER pad again and it will go to
the preset
points of O°Ffi)r
the fl'eezer and
37°Ffi)r
the refi_igeratox: Setting either or both controls
to Off stops cooling in both the fl'eezer and
refl_igerator compartments, but does not shut
off electrical power to the refi_igeratm: