Olsberg CTSC 14/522 Instrucciones De Montaje página 28

OLSBERG Standard heater CTSC
14/522 14/523
1
Opening the heater (Fig.4):
1. Prise off the plastic caps and remove the
screws.
2. Lift the top panel approx. 10mm.
3. Pull the top panel forward and out.
4. Pull the rear top panel forward and out.
5. Take hold of the side panels at the front and
jerk outwards.
Important:
The right-hand side panel is fixed to the
heater with a strain relief cable so that the
room temperature sensor cannot be damaged
when the heater is opened. Do not remove
this strain relief!
Note:
The side panel can be removed from the
heater without taking off the top cover panel.
Prise off the right-hand plastic cover cap and
remove the screw, push the air-outlet grille to
the left, thread the tip of a screwdriver on to
the edge of the fluff filter and push the right
hand side panel outwards. Please take care to
avoid damaging the fluff filter. If necessary,
remove the fluff filter first.
Remove the top insulation, packaging and as-
sembly material. For reasons of safety against
breakage, the cover panel insulating mats are
laid inside the heater, upright against the front
panel insulation during transport.
2
Place the heater in its final position. Align the
tilting safety screw in its final position on the right
or left hand inner panel and fix it firmly to the wall
(Fig.5).
28
14/524 14/525 14/526 14/527
1.
Fig.4
Fig.5
4.
3.
2.
1.
5.