DeWalt DW089 Manual De Instrucciones página 35

USING THE LASER WITH THE WALL MOUNT (FIG. 3)
The laser wall mount (J)
FIG. 3
offers more mounting
options for the DW089
laser. The wall mount has a
clamp (K) at one end which
can be fixed to a wall angle
for acoustic ceiling
installation. At each end of
the wall mount is a screw
hole (L), allowing the wall
mount to be attached to
any surface with a nail or
screw.
Once the wall mount is secured, its steel plate provides a surface to
which the magnetic pivot bracket (F) can be attached. The position
of the laser can then be fine-tuned by sliding the pivot bracket up or
down on the wall mount.
ALIGNING THE VERTICAL BEAM – FINE ADJUST (FIG. 4)
The fine adjustment knob (H) on the top
of the DW089 is for lining up the vertical
beams. Place the DW089 on a flat
surface and turn the knob to the right to
move the beam to the right or to the left
to move the beam to the left.
Rotating the fine adjustment knob
adjusts the entire internal mechanism,
maintaining the 90° angle between the
two vertical beams.
LEVELING THE LASER
As long as the DW089 laser is properly calibrated, the laser is self-
J
leveling. Each laser is calibrated at the factory to find level as long as it
F
is positioned on a flat surface within average ± 4° of level. No manual
adjustments are required.
Maintenance
• To maintain the accuracy of your work, check the laser often
K
• Calibration checks and other maintenance repairs may be
L
• When not in use, store the laser in the kit box provided. Do not
• Do not store your laser in the kit box if the laser is wet. The laser
NOTE: Disassembling the laser level will void all warranties on the
product.
FIG. 4 Cleaning
H
Exterior plastic parts may be cleaned with a damp cloth. Although
these parts are solvent resistant, NEVER use solvents. Use a soft, dry
cloth to remove moisture from the tool before storage.
35
to make sure it is properly calibrated. See Field Calibration
Check.
performed by D WALT service centers.
E
store your laser at temperatures below –5 °F (–20 °C) or above
140 °F (60 °C).
should be dried first with a soft dry cloth.