Crosley 302 Manual De Instrucciones página 4

English
Setup
Dial Mode
Locate the DIAL MODE switch on the rear of the telephone body. Slide the
switch to TONE unless you have Dial-Pulse (Rotary) telephone service in your
area in which case, slide the switch to the PULSE position.
Ringer Control
The RINGER CONTROL switch on the rear of the telephone allows you to turn
the ringer ON or OFF. You can still make or receive calls with the ringer in OFF
position, however, you will not hear the incoming ring.
Receiver Volume
The RECEIVER VOLUME CONTROL switch, located on the rear of the
telephone body, allows you to adjust the volume of the receiver earphone from
LOW and HI.
Handset Cord
To assemble, insert the end of the handset cord into the HANDSET CORD JACK
located on the left side of the telephone body.
Installation
Wall
If you are not mounting directly onto a modular wall jack, proceed as follows:
1. Install the line cord into the LINE CORD jack on the back of the telephone. If
the desired location is farther than 7-foot from a wall jack, you will have to
obtain a longer line cord available at most hardware stores.
2. Place the provided TEMPLATE against the wall in the position desired.
3. Mark the wall by poking either a pen or pencil through the indicated spots on
the template.
4. If there is no stud at this location, it will be necessary to install the provided
wall anchors. Drill a small pilot hole at the marked locations. Tap the anchors
into the holes. Then insert screws, but DO NOT TIGHTEN. Leave the screw
heads protruding about ¼ inch.
5. If there is a stud at this location, simply install the two screws into the stud.
Remember to leave screw head protruding.
6. Telephone is then mounted according to procedure detailed in mounting to
modular plug.
Note: If you encounter difficulty fitting the telephone body onto the screws, or the telephone
wobbles when installed, either tighten or loosen the screws to adjust.
4