WMF MASTER Manual Del Usuario página 10

5.2| SOUND SETTINGS
Double click on the rotary knob (9) to reach
the setting mode. The settings symbol (14) will
appear on the display (10), with a certain level
of sound volume (by default L3). Turn the rotary
knob (9) to set the volume higher or lower and
press it to confirm.
5.3| TEMPERATURE UNIT SETTING
Double click on the rotary knob (9) to reach
the setting mode, then once again to reach the
temperature unit setting mode. Choose between
°F and °C with the rotary knob (9) and press to
confirm.
6| CLEANING AND CARE
After use, remove the mains plug and allow the
device to cool down. Do not immerse the device
in water, but rather clean them with a damp
cloth with a little washing-up fluid and then
dry off.
Do not use any sharp and abrasive cleaning
agents.
The pot (6) is made of stainless steel. Should
rust spots nevertheless appear, they are only
deposits adhered to the surface. They should
be removed immediately with a stainless steel
cleanser.
The strainer insert (3) in the pour spout can be
removed for cleaning when the lid is open. To
do so, press its upper clip upward. When insert-
ing, place the strainer (3) in the middle of the
base and then snap it forward into place.
Descaling
Please descale your appliance regularly using a
high-quality commercial descaling agent. Fol-
low the manufacturer's instructions, particularly
with regard to the subsequent cleaning with
clear water, which is essential! Suitable descal-
ing agents contain inhibitors that protect appli-
ances against damage to seals and surfaces, do
not cause additional deposits and have no taste.
Do not use descaling agents that are unsuitable
for your appliance (such as substances based
purely on vinegar or citric acid). Our warranty
does not cover damage caused by using unsuit-
able descaling agents or failure to follow the
descaling instructions. Please keep descaling
agents out of reach of children and make sure
you do not inhale any of the steam given off
during descaling.
7| CAUSES FOR MALFUNCTIONS
If the pouring behaviour worsens/
diminishes:
Check the strainer (3) and descale/clean the strainer
if necessary.
Device switches off before boiling:
Bottom of the pot is too strongly calcified;
it is not filled with enough water.
Device does not switch off:
Lid (1) is not closed.
Device will not switch on:
The device has not sufficiently cooled down
following operation with no or too little water.
Before any further usage, the kettle must be taken
from the base (7) and put back on again.
If it is not possible to fix this problem, submit
the device for repair.
18
8| TECHNICAL SPECIFICATIONS
Nominal voltage: 220 -240 V~ 50 – 60 Hz
Power consumption: 2000-2400 W
Protection class: I
The appliance complies with European
directives 2014/35/EU, 2014/30/EU and
2009/125/EU
Environment
Environment protection first!
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
19