Fronius RC Pedal TIG /TMC Manual De Instrucciones página 16

General
Device concept
Requirements The remote controls can be operated with the following power sources:
RC Panel TIG /TMC:
-
-
RC Panel TIG /BT:
-
-
-
Options
TMC extension 5 m
Bluetooth trade- The Bluetooth® word mark and logos are registered trademarks owned by Blue-
marks tooth SIG, Inc. and any use of such marks by Fronius International GmbH is un-
der license. Other trademarks and trade names are those of their respective ow-
ners.
16
iWave 190i, iWave 230i
TransTig 170, TransTig 210
iWave 230i
TransTig 170, TransTig 210
Only in certified countries
The RC Pedal TIG /TMC and RC Pedal
TIG /BT remote controls allow the wel-
ding current to be easily adjusted with
the aid of a foot pedal.
The welder's hands remain free, mea-
ning that in addition to constant wel-
ding current correction, uninterrupted
torch guidance is guaranteed.
When a remote control is connected or
a Bluetooth connection established,
the welding current set on the power
source is deemed the maximum cur-
rent. The total pedal travel corre-
sponds to the range from the minimum
welding current to the maximum wel-
ding current.
At low welding currents, the remote
control allows for especially sensitive
adjustment.
43,0004,5979