Fronius RC Pedal TIG /TMC Manual De Instrucciones página 23

Setting the wel-
ding current and
welding
Danger due to incorrect operation and incorrectly performed work.
This can result in serious injury and damage to property.
▶
IMPORTANT! When the remote control is connected or the Bluetooth connec-
tion is established, the welding current set on the power source is only available
when the pedal is fully depressed.
NOTE!
Parameters which can be adjusted on the remote control cannot be altered on
the power source.
1
2
If the remote control's pedal is released, the welding process comes to an end in
a controlled manner (gas post-flow, end of welding).
WARNING!
Do not use the functions described until you have thoroughly read and un-
derstood the Operating Instructions of the remote control, the power source
and all other system components.
Set the welding current on the power source
Actuate the pedal
The ignition process is initiated (value change 5%).
23