Black and Decker NPP2018 Manual De Instrucciones página 13

Accessories
Replacement chain and bar are available from your nearest Black &
Decker service center.
Replacement chain # 623382-00
Replacement bar # 623381-00
The use of accessories not recommended in this manual may be
hazardous.
Troubleshooting Section
If your Pole Saw does not operate correctly check the following:
Problem Possible Cause Possible Solution
• Tool wilt not • Battery not
start, installed properly.
• Battery not •
charged.
• Lock-out button not •
actuated.
• Pole connections •
not properly
tightened.
• Unit wilt not • Battery not
charge, inserted into
charger.
• Bar / chain • Chain too tight. •
overheated.
• Lubrication •
needed.
• Chain is • Chain tension set •
loose, incorrectly.
• Poor cut • Chain tension set •
quality, incorrectly.
• Chain needs
replacement.
Check battery installation.
Check battery charging
requirements.
Pull back on lock
button/actuate trigger.
Refer to instruction manual
for pole connections.
Insert battery into charger
until red LED appears.
Charge up to 8 hours if
battery totally drained.
Refer to section on
adjusting chain tension.
Refer to sections for chain
oiling application.
Refer to section for chain
tensioning.
Refer to section on
adjusting chain tension.
Note: Excessive tension
leads to excessive wear
and reduction in life of bar
& chain.
Lubricate after every 10
minutes of use.
Refer to section for
installation of chain.
13