Disposal; Troubleshooting; Ec Declaration Of Conformity - Fimap UP36 Manual De Uso Y Mantenimiento

To dispose of the appliance, take it to a demolition centre or an
authorised collection centre.
Before scrapping the appliance, it is necessary to remove and
separate out the following materials, then send them to the
appropriate collection centres in accordance with applicable
environmental hygiene regulations:
• Brush
• Electric and electronic parts*
• Plastic parts
• Metallic parts
This chapter lists the most common problems linked with the use of the appliance. If you are unable to resolve the problems with the
information given here, please contact your nearest assistance centre.
PROBLEM
The appliance doesn't work.
The appliance suddenly stops
vacuuming.
The appliance doesn't pick up any type
of dirt.
The brush does not work.
The operation of the appliance is noisy .
The undersigned manufacturer:
FIMAP S.p.A.
Via Invalidi del Lavoro n.1
37059 Santa Maria di Zevio (VR)
Declares under its sole responsibility that the products
UPRIGHT VACUUM CLEANER, models UP36 - UP46
Comply with the requirements of the following Directives:
• 2004/108/EC
• 2006/95/EC
• 2001/95/EC
• 2011/65/EC

DISPOSAL

(*) In particular, contact your distributor when scrapping electric and
electronic parts.

TROUBLESHOOTING

POSSIBLE CAUSE
The plug is not plugged in or the power is
not switched on.
The outlet is not powered.
The power cable is damaged.
The overheating protection has tripped
(probably due to the clogging of the air
ducts, dirty filters etc.)
The dust bag is full.
One of the vacuum motor filters (inlet filter
or outlet filter) is clogged.
Lance, vacuum pipe and vacuum hose
are blocked.
The lance inserted is not suitable for the
type of flooring.
The carpet/floor selector is in the wrong
position with respect to the type of flooring.
The connection cable is loose or not
connected. Vacuum pipe loose.
The particles vacuumed block the air duct.

EC DECLARATION OF CONFORMITY

32
SOLUTION
Plug the plug to the power outlet and turn
on the appliance.
Check the appliance in another outlet
where you are sure power is supplied.
Have the power cable replaced by an
authorized Service Centre.
Turn off and disconnect the appliance.
Eliminate the cause of the overheating (e.g.
intake ducts clogged, dirty filters, etc.). Wait
30 minutes and allow the appliance to cool.
The turn on the appliance again.
Replace the dust bag, read chapter
"MAINTENANCE".
Clean or replace the relative filter, read
chapter "MAINTENANCE".
Remove the obstruction. Use a long
wooden rod if necessary (e.g. broom
handle).
Insert the correct lance.
Adjust the position of the carpet/floor
selector to the flooring type.
insert correctly the connection cable. Insert
correctly the vacuum pipe. Read chapter
"APPLIANCE PREPARATION".
Remove the particles. Use a long wooden
rod if necessary (e.g. broom handle).
The person authorised to compile the technical file:
Mr. Giancarlo Ruffo
Via Invalidi del Lavoro n.1
37059 Santa Maria di Zevio (VR) - ITALY
Santa Maria di Zevio, 09/02/2015
Legal representative
FIMAP S.p.A.
Giancarlo Ruffo