Publicidad
Idiomas disponibles
Idiomas disponibles
co
OPERATING AND ASSEMBLING MANUAL
-(Fig.I) One-time attachment of the holding fixtures
Attach the holding fixtures (1} from underneath the rear axle of
the buggy. Make sure that the attachments are mounted
above the braking distributer. Poy attention to the arrows,
which
should
be pointing in the driving direction, os well os the
labels
,L'
for left and
,R'
for right facing the driving direction.
Then you can insert both holding brackets (2} from above into
the holding fixtures and attach them with two screws (3} on
the underside
-(Fig.11)
Use the adapters (4} to attach the Mamaboard to the holding
fixtures (5} until they audibly click into place. lf you would like
to remove the Mamaboard, push the locks (5} back.
-(No illustration)
When you are not using the Mamaboard, you can clap it
up and attach it with the pin on the underside of the
board to the transportation security belt.
CARE INSTRUCTIONS
- Clean all parts with a damp cloth.
- Do not use ony caustic cleaning or lubricating agents!
- An
oil spray on the folding joints and the wheel bearings
Vvill
guarantee smooth
running.
- You can wash the seat cover by hand at 30°.
- Not suitable for a woshing machine or tumble dryer!
- The tires can cause eventually a discoloration of the floor surfacing.
Foreign bodies in the tires (such os small stones) have to be removed in order
to prevent a possible damage of the floor surfacing.
WARRANTY CONDITIONS
The
statutory
provisions shall apply for justified complaints. As proof of
purchase, please keep the till receipt for the duration of the statutory period
of limitation. This term is 2 years
*)
and starts
with
the handover of the
product to
you.
Should ony faults arise in relation to this product, they
shall
involve ony faults of material and manufacture that exist at the date of
transfer. Any claims
shall
be excluded for:
•
Natural wear and damage due to excessive stress
•
Damage due to unsuitable or improper use
•
Damage due to faulty assembly and commissioning
•
Damage due to negligent handling or maintenance
•
Damage due to improper modifications to the pushchair
Faults must be notified immediately,
so
that no
subsequent
damage can be
caused!
A
case for compfaint or not?
•
Most TFK products are produced to a large extent from aluminium and so
are rust-proof. However, some parts are also painted, galvanized or have
other surface protection. These parts may rust. depending on the level of
maintenance and stress.
This
can therefore not be regarded os a fault.
•
Scratches are norma!
signs
of wear and are not a fault.
•
Moist textiles that are not dried can moulder and so can not be considered
os a production-related fault.
•
The fading of colours due to sunshine, perspiration. cleaning agents.
abrasion or excessively frequent washing cannot be ruled out and so does
not represent a fault.
•
Pleose check carefully at the time of purchase
whether
all the fabric parts.
seams. press studs and zips are sewn and function properly.
•
Worn-down wheels are of course a
sign
of
wear.
Damage due to external
influences is not a fault. Slight imbalances are inevitable and do not
represent a fault. The handover check must always be carried out to prevent
inconvenient
problems
right
at the outset.
li
you
find
a
fault
at a later date.
pleose notify your authorised dealer
immediately.
He
will then contact us to discuss
the
subsequent procedure. Any deliveries
to
TFK
that are unnotified or not prepaid
will
not be accepted.
*) valid only
in the EU
.
ln
other
countries
according
to
the
respective
warrenty terms.
°'
Publicidad
