Descargar Imprimir esta página

Hart HFSC51 Manual Del Operador página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

FEATURES
PRODUCT SPECIFICATIONS
Motor ............................................................................................................................................................................4 V DC
No Load Speed (revolutions per minute) ......................................................................................................... 265/min (RPM)
Waterproof Rating .......................................................................................................................................................... IPX7*
* IP Rating: Specifies the environmental protection the product enclosure provides. This product has an IPX7 rating meaning it can withstand immersion
in water up to 1 meter for up to 30 minutes.
ASSEMBLY
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-776-5191 for assistance.
OPERATION
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use
of attachments or accessories not recommended can
result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
z The power scrubber can be used to clean exterior and
interior surfaces.
z This product is not for commercial use.
WARNING:
Battery tools are always in operating condition. Make
sure the power button is off when the product is not in
use or when carrying at your side.
WARNING:
Do not attempt to modify this product or create accesso-
ries or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
TO CHARGE
See Figure 1, page 8.
z Turn the power scrubber off.
z Make sure the USB charging port is dry.
z Insert the USB cable into the product as shown.
z Connect the USB cable to any powered USB port, or
connect it to a USB power adapter (not included) and
plug the adapter into a power supply.
NOTE: Make sure the power supply is normal household
voltage, 120 volts, AC only, 60 Hz.
z Located beside the USB-C port, the LED light will flash
green while charging and will turn solid green once the
tool is fully charged or while in use.
z Do not place charger in an area of extreme heat or cold.
It will work best at normal room temperature.
z Remove the product from the USB power adapter (not
included) or powered USB port once it is fully charged,
the LED will be solid green and ready for use.
z Disconnect the USB cable from the tool.
5 – English

Publicidad

loading