Bosch HMV3022U Manual De Instalación página 12

8.Attachthe exhaust a dapter to the rearofthe ovenby
slidingit intothe guides.Pushinsecurely untilit is in
the lowerlockingtabs.Makesurethe damperhinge
swingsfreely.
ll
Preparing cabinet
1. Remove power to outlet.
2. Remove all contents from upper cabinet.
3. Tape the TOP CABINET TEMPLATE onto the bottom
surface. Make sure the template centerline aligns with
the vertical line on the wall. Rear wall arrows must be
against rear wall.
!
Note: For recessed cabinet bottom, trim the template
edges so that it fits inside the recessed area. The
template has trim lines to use as guides.
4. Drill 3\8" (9,5 mm) holes at "A", "B" and "C".
Note: Wear safety goggles when drilling holes in the
cabinet bottom.
5. Cut out the 2" (50,8 mm) hole at "D". This hole is for
the power supply cord.
Note: If the cabinet is metal, use the nylon grommet
around the opening to protect the cord.
6. Roof venting installation only: Cut out the shaded
area "E" on the template, using a saber or keyhole
saw.
Wall venting installation only: Preparing rear wall
For wall venting installation you need to cut out an
opening on the rear wall.
• , CAUTION
If exhaust adaptor is positioned outside consider
recommended dimensions, otherwise grease-laden
air will discharge into house structure.
1. Mark the centerline (See Attaching the mounting plate
to the waft) 3\8" (10 mm) down from the top of the
mounting plate.
Using measuring tape, measure out 6" (152 mm) on
both sides of the centerline, and mark.
Measure down 4" (102 mm) from the mark made in
Step 1, and mark.
Using a straight edge, draw the 2 horizontal level lines
through the marks made in Steps 1 and 3.
,
3.
4.
12