A
IMPORTANT
SAFETY
INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE
APPLIANCE AFTER INSTALLATION IS COMPLETE.
IMPORTANT: SAVE THESE INSTRUCTIONS FOR THE
LOCAL ELECTRICAL INSPECTOR'S USE.
WARNING
If the information
in this manual is not followed exactly,
fire or shock may result causing property damage or
personal injury.
WARNING
Do not repair, replace or remove any part of the
appliance
unless specifically
recommended
in the
manuals. Improper installation, service or maintenance
can cause injury or property damage. Refer to this
manual for guidance. All other servicing should be done
by a qualified technician.
Appliance
Handling
Safety
Unit is heavy and requires at least two people or proper
equipment to move.
Do not lift appliance
by door handle.
Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.
Safety Codes and Standards
This appliance complies
with the latest version of one or
more of the following standards:
o CAN/CSA C22.2 No. 61 - Household Cooking Ranges
o UL 858-
Household Electric Ranges
o CAN/CSA C22.2 No. 150 - Microwave Ovens
o UL 923 - Microwave Cooking Appliances
o UL 507-
Electric Fans
o CAN/CSA C22.2 No. 113 - Fans and Ventilators
o CSA C22.2 No. 64 - Household Cooking and Liquid-
Heating Appliances
o UL 1026 - Electric Household Cooking and Food
Serving Appliances
It is the responsibility
of the owner and the installer to
determine if additional
requirements
and/or standards
apply to specific installations.
State of California Proposition 65
Warnings
WARNING
This product contains chemicals known to the State of
California to cause cancer, birth defects or other
reproductive
harm.
Electric Safety
WARNING
Before you plug in an electrical
cord or turn on power
supply, make sure all controls are in the OFF position.
For appliances
equipped with a cord and plug, do not
cut or remove the ground prong. It must be plugged into
a matching grounding type receptacle
to avoid electrical
shock. If there is any doubt as to whether the wall
receptacle
is properly grounded,
the customer should
have it checked by a qualified electrician.
If required by the National Electrical Code (or Canadian
Electrical Code), this appliance
must be installed on a
separate branch circuit.
Installer - show the owner the location of the circuit
breaker or fuse. Mark it for easy reference.
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
ON accidentally.
Be sure your appliance
is properly installed and
grounded
by a qualified technician.
Installation, electrical
connections
and grounding
must comply with all
applicable
codes.
Microwave
Safety
PRECAUTIONS TO BE OBSERVED BEFORE AND
DURING SERVICING TO AVOID POSSIBLE EXPOSURE
TO EXCESSIVE MICROWAVE ENERGY
o Do not operate or allow the oven to be operated with
the door open.
o Make the following safety checks on all ovens to be
serviced before activating the magnetron or other
microwave source, and make repairs as necessary:
1. Interlock operation
2. Proper door closing
3. Seal and sealing surfaces (arcing, wear, and other
damage)
4. Damage to or loosening of hinges and latches
5. Evidence of dropping or abuse
o Before turning on microwave power for any service
test or inspection
within the microwave generating
compartments,
check the magnetron, wave guide or
transmission
line, and cavity for proper alignment,
integrity, and connection.
o Any defective or misadjusted
components
in the
interlock, monitor, door seal, and microwave
generation
and transmission
systems shall be
repaired, replaced, or adjusted by procedures
described
in this manual before the oven is released
to the owner.
A microwave leakage check to verify compliance
with
the Federal Performance
Standard should be
performed
on each oven prior to release to the owner.
3