Johnson MANANTIAL Serie Manual De Conexión página 16

Step 5: When "Scan device", " Register on Cloud" and "Initialize the device" are all done, the
connection is successful, and the system prompts "Device Added successfully", then the
network distribution is successful. In this interface " ", you can change the device name,
select the device installation location (living room, master bedroom...), and then click
"Done" to directly enter the main interface of device operation;
2.2 Wi-Fi distribution network-Blink Slowly:
Step 1: Press and hold the "Switch" button and the "-" button at the same time for 5
seconds. When entering the Wi-Fi network distribution mode, the "Cloud" icon will blink
slowly, and the mobile phone can start network distribution. After 3 minutes, it will exit the
network distribution state.
"Cloud" icon stops blinking, and the WIFI module no longer distribute the network. If you
want to enter the distribution network again, you need to press and hold the "Switch"
button and the "-" button for 5 seconds again;
Step 2 and Step 3: Consistent with Wi-Fi distribution network - Blink Quickly
Step 4: After selecting the water heater, enter the "Add Device" interface, confirm that the
wire controller has been operated and enter the "Blink Slowly" network distribution mode,
and after the "cloud" icon is in the Blink Slowly state, click "confirm that the indicator is
blinking" and select "Blink Slowly"; the WIFI connection interface pops up, enter the WIFI
password(must be consistent with the WIFI connected to the mobile phone), and click Next;
6 6
V.1