Publicidad
Idiomas disponibles
Idiomas disponibles
1600A0235F.qxp_GKS18-25C 4/20/20 8:17 AM Page 15
Bevel Adjustment
A.
Disconnect battery pack from tool.
B.
Loosen the bevel adjustment lever 5.
C.
Align to desired angle on the bevel scale
7. The foot can be adjusted up to 50°.
D.
Tighten lever 5 (Fig. 5).
Because of the increased amount of blade
engagement in the work and decreased
stability of the foot, blade binding may
occur. Keep the saw steady and the foot
firmly on the workpiece.
Cutting Line Guide Notches
The marked notches 8 and 9 at the front of
the footplate indicate the approximate line
of the cut (Fig. 7).
•
For a non-bevelled cut, use 0° notch 8.
•
For 45° and 50° bevel cuts, use 45°
notch 9.
•
To ensure minimum splintering on the
good side of the material to be cut, face
the good side down.
•
Make sample cuts in scrap lumber to
verify actual line of cut. This will be
helpful because of the variety of blade
types and thicknesses that are available.
•
Use RIGHT side of notch when the part
of the workpiece that is to the left of the
blade is the scrap piece (Fig. 7a).
•
Use LEFT side of notch when the part of
the workpiece that is to the right of the
blade is the scrap piece (Fig. 7b).
Fig. 7
Fig. 7a
ind Quality Products Online at:
Operating Instructions
8
9
Fig. 7b
45°
0°
GlobalTestSupply
www.
Connectivity
operating instructions included with
Bosch connectivity module. Operating
instructions for connectivity module
include important information not covered
in this manual.
This power tool is Bluetooth capable and
select features can be adjusted remotely
using a mobile device. Utilizing these
features requires installation of a Bosch
Bluetooth connectivity module and a
mobile device with the Bosch Toolbox app
installed.
If connectivity module is not purchased
with the tool, or if the replacement of the
module or the battery becomes necessary,
please follow this procedure (See Fig. 8a):
-
Using a flat screwdriver or a coin,
remove the cover A from the side of the
handle, by turning it 1/4 turn counter-
clockwise (Fig. 8a or 8b).
-
If the tool is already equipped with the
connectivity module, remove the battery
B, but do not remove the connectivity
module C.
Fig. 8a
Fig. 8b
45°
0°
To reduce the risk of
injury
read
A
B
C
A
D
.com
sales@GlobalTestSupply.com
the
15
Publicidad
