Publicidad
Idiomas disponibles
Idiomas disponibles
Basic Operation
"REPLACE BATT" LED: This red light will illuminate constantly and the
UPS alarm will beep every 2 seconds if UPS microprocessor detects a
battery fault or if your UPS fails the automatic self-test (after you turn
your UPS ON) and the UPS battery is less than fully charged. Let the UPS
system charge for at least 12 hours and perform a self test using the
"ON/TEST Button" as described on page 7. If the light continues to stay
on, contact Tripp Lite for service.
Rear Panel
Accessory Slot: Remove the small cover panel from this slot to use
optional accessories to remotely monitor and control your UPS. Visit
www.tripplite.com for compatible SNMP , network management and
connectivity products.
External Battery Pack Connector (Varies by Model): Use to connect
optional Tripp Lite Battery Packs for additional runtime. Visit www.tripplite.
com/products/battery-finder/ to find a compatible battery pack. Refer to
your external battery pack Owner's Manual for complete connection
information and safety warnings.
Fan: The fan cools the UPS internal components. It is always on when
line power is present.
Input Circuit Breaker Switch: This resettable breaker prevents high
input current from damaging the UPS or the attached load. If this breaker
trips, make sure your UPS is connected to AC power of the proper
voltage before resetting the circuit breaker by pushing the breaker switch
in.
Ground Screw: Use this to connect any equipment that requires a
chassis ground.
Output Circuit Breakers Switches (Select Models Only): These
resettable circuit breakers protect your UPS from output overload. If one
or both breakers trip, remove some of the load on the circuit(s) and allow
the UPS to cool before pressing the breaker switch(es) in to reset.
Input Cord: This permanently attached power cord connects your UPS to
a power outlet.
11
17-05-032-932471.indb 11
5/23/2017 1:41:49 PM
Publicidad
