Descargar Imprimir esta página

Xblitz BLACK 4K Manual Del Usuario página 10

Publicidad

system (depending on the card) and then in the recorder.
Also check: Is the selected card capacity and specification (micro SD, class 10
- U1, V10 additionally recommended) suitable for your device (we recom-
mend using cards from reputable manufacturers, we recommend: Kingston,
Samsung, Sandisk). If at any stage you encounter an error, replace the card
with a new one from official distributors.
7. The device records noise, distorted, unclear sound
The device has a highly sensitive microphone that records any ambient
noises. The recorded sounds may overlap. Windscreen air vents can also
distort the sound.
8. Device does not respond
Press the Reset button briefly or return the device to factory settings.
9. The footage shows transverse lanes
Incorrect setting of the frame rate value. Set the frequency value to „50Hz"
or „60Hz" depending on local settings.
10. Handle detaches from the windshield/does not stick
Degrease the surfaces well before mounting the holder on the glass.
Remember to avoid high temperatures, which can cause deformation of the
holder, and damage to the recorder itself.
NOTES:
- G-SENSOR - a function thanks to which recordings with recorded overloads (e.g.
uneven road surface, braking, driving off a kerb or over a speed bump, etc.) are
protected from being overwritten. If you use this function, you must periodically
format the memory card on your computer and then on the camera. Ultimately,
each file on the data carrier will be protected from being overwritten and the
device will not be able to record a further route - it will not record in a loop. We
suggest setting the sensor according to your driving style and road conditions. This
option can also be completely disabled, in which case each of the oldest files will be
overwritten and the card will not need to be formatted periodically.
- PARKING MODE/MONITOR - a function designed to operate while the vehicle is
parked, uses battery power* if the recorder is fully charged - (*if it has a built-in
battery) . In this case, the camera starts recording a few seconds of video after
detecting a shock - until the battery is discharged. When using this function, bear in
mind the battery of the device, which needs to be recharged after the function ac-
tivates (starts). You should deactivate the function, before setting off on a journey,
as it may cause the camera to switch on and off and make random fragments of
recordings from the route.
*The constant power supply in the vehicle may cause this function to behave
differently, e.g. leaving the camera on, which may drain the car battery.
- MOVEMENT DETECTION - a function designed to operate while the vehicle is
18
parked - requires constant power and the camera must remain switched on. The
DVR will start recording automatically when motion is detected, and will stop recor-
ding a few seconds after there is no movement in front of the camera lens. Please
note that this function can drain the car's battery.It is necessary to deactivate the
function, before setting off on a journey, as it can cause the camera to switch on
and off and make random fragments of recordings from the route.
09. NOTE
1. Due to continuous product improvement, the manufacturer reserves the
right to make changes to the device and its kit without prior notice. Some
functions described in this manual may differ slightly from reality.
2. Use only the original charger with a charging current of 5V/2A. Do not con-
nect directly to a 220/230 V outlet. Failure to do so may damage the camera
or lead to dangerous situations.
3. The GPS module may lose connection with the satellite if you are indoors
or travelling through an underground tunnel. Occasionally, there may also
be random signal disturbances due to electromagnetic interference. The
manufacturer is not responsible for possible errors or inaccurate position
indications by the GPS.
4. The parking mode function is based on battery power. A camera with a
charged battery and active parking mode will, upon detecting a shock, start
up and record a short recording and then switch off automatically to reduce
battery consumption. The manufacturer accepts no responsibility for failure
to record any damage caused when using the camera in parking mode.
10. SPECIFICATION
Processor: NTK96675
Sensor: Sony Starvis IMX307
Lens: 6G+IR
Aperture: 1.8
Recording resolution: 4K - 30 FPS / 2K - 30 FPS / FHD - 60 FPS
Viewing angle: 170 degrees
Codec: H.264/H.265
G-Sensor: YES
Parking mode: YES
Loop Recording: YES
Night mode: YES
WiFi: NO
GPS: YES
Battery: built-in Li-Po 200 mAh battery
Power supply: DC 5V/2A
19

Publicidad

loading

Productos relacionados para Xblitz BLACK 4K