Description - Hilti DX 76 Manual De Instrucciones

Obligation signs
en Wear eye Wear a hard
protection
Symbols
Read the
operating
instructions
before use

2 Description

2.1 Use of the product as directed
The tool is intended for use in the construction industry and associated trades for driving fasteners into steel.
The tool is for hand-held use only.
Modification of the tool is not permissible.
The tool may not be used in an explosive or flammable atmosphere unless it has been approved for use under these
conditions.
To avoid the risk of injury use only genuine Hilti fasteners, cartridges, accessories and spare parts or those of
equivalent quality.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used
not as directed.
The tool may be operated, serviced and repaired only by trained personnel. This personnel must be informed of any
special hazards that may be encountered.
As with all powder-actuated fastening tools, the tool, magazine, cartridges and fasteners form a technical unit. This
means that trouble-free fastening with this system can be assured only if the Hilti fasteners and cartridges specially
manufactured for it, or products of equivalent quality, are used. The fastening and application recommendations given
by Hilti apply only when these conditions are observed.
For optimum results and maximum reliability we recommend use of Hilti cartridges or products of equivalent quality.
The following also applies in EU and EFTA countries: For maximum safety with this tool, the cartridges must comply
with the requirements of the applicable C.I.P. tests (source: Comprehensive edition of adopted C.I.P. decisions, Liège,
Belgium, 2005) as well as the cartridge tests described at www.hilti.com/cartridgetest.
The tool features a 5-way safety system for the safety of the user and all bystanders.
2.2 Piston principle with piston brake
The energy from the propellant charge is transferred to a piston, the accelerated mass of which drives the nail into the
base material. Due to use of this piston principle, the tool is classified as a "low velocity tool". Approximately 95% of
kinetic energy is taken up by the piston when the tool is fired. As the piston is always stopped by the tool as it reaches
the end of its travel, excess energy is absorbed by the tool. Accordingly, when the tool is used correctly, dangerous
through‐shots (i.e. with a nail muzzle velocity of over 100 m/s) are virtually impossible.
2.3 Drop-firing safety device
The drop-firing safety device is the result of coupling the firing mechanism with the cocking movement. This prevents
the tool from firing when dropped onto a hard surface, no matter at which angle the impact occurs.
2.4 Trigger safety device
The trigger safety device prevents the tool firing when only the trigger is pulled. The tool must be pressed against a
firm surface before a fastener can be released.
2
Wear ear
hat protection
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Wear
protective
Type:
gloves
Generation: 01
Serial no.: