Publicidad
Idiomas disponibles
Idiomas disponibles
2.2
Parts identification
Figure 2: Main parts identification.
Figure 3 shows the cross section of the layers in the decal process. In this process the
largest number of layers is possible.
Figure 3: Cross section of layers, when making a decal.
Decaling in general is a cold process, where the bottom layer has no release liner. The
removable foil (6 = release liner) is not removed during the decal process. The carrier (5)
is not always present. In this case the removable foil (6) also functions as carrier.
The top layer is a normal pressure sensitive laminate, in this case with a release liner.
Heat sensitive laminates in general have no release liners (4), so they just consist of the
laminate (2) with a heat activated adhesive layer (3).
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
12
Toll Free: 1-800-944-4573
Local: 503-640-5920
1
Nip setting and pressure control wheel
2
Main rollers
3
In-feed table with image guide
4
Auto-grip shaft
5
Emergency button
6
Heater controls
7
Top unwind shaft
8
Control panel
9
Unwind/wind-up shaft
10 (Upper) wind-up shaft
11 Splitter bar
12 Nip safety bar with optional slitters
13 Pull rollers
14 Output table with optional cooling device
15 Foot switch
16 Identification label
17 Main power switch
User Manual 62Pro
Publicidad
