After Using The Machine; Maintenance Schedule; Important; Vacuum Shoe Maintenance - Clarke Clean Track S16 Instrucciones De Uso

A - ENGLISH

AFTER USING THE MACHINE

1 Turn the Power Switch (14) OFF (O). Unplug the Power Cord (10). Coil the cord and hang it from the cord hook.
2 To empty the solution tank, pull the Solution Drain Hose (15) off the elbow. Direct the hose to a designated waste water "DISPOSAL SITE".
Rinse the tank with clean water. Inspect the solution hoses; replace if kinked or damaged.
6 To empty the recovery tank, take the Recovery Drain Hose (12) off its hanger. Direct the hose to a designated waste water "DISPOSAL SITE"
and remove the plug (hold the end of the hose above the water level in the tank to avoid sudden, uncontrolled fl ow of waste water). Rinse the
tank with clean water. Inspect the recovery and drain hoses; replace if kinked or damaged.
4 Remove the brush, rinse with warm water and remove any built-up string, hair or carpet fi bers.
5 Disconnect the Recovery Hose (3) from the Recovery Tank Dome Lid (4) and fl ush with warm water to wash any debris out of the Recovery
Hose and Vacuum Shoe.
6 Wipe the machine with a damp cloth. Do not use abrasive chemicals or solvents.
7 Perform any required maintenance before storage.

MAINTENANCE SCHEDULE

Check / Clean Power Brush
Check / Clean Tanks & Hoses
Check / Clean Vacuum Shut-Off Float
Inspect & Clean Solution Screen
*Check Carbon Brushes
* Have a Clarke service technician check the vacuum motor carbon brushes once a year or after 300 operating hours. The brush motor carbon
brushes check every 500 hours or once a year.

IMPORTANT!

Motor damage resulting from failure to service the carbon brushes is not covered under warranty. See the Limited Warranty
Statement.
8 Store the machine indoors in a clean, dry place with the tank dome lid open. Keep from freezing.
9 Place the machine in the storage position. Tip the machine back to lift the vacuum shoe off of the fl oor, then push in and up on the Brush
Pressure Control Knob (17) until the knob locks into place.

VACUUM SHOE MAINTENANCE

Check the vacuum shoe daily. Remove any built-up string, hair or carpet fi bers. See Figure 6. The vacuum shoe can be removed by pulling on the
Pin Release (7) and sliding the Vacuum Shoe (8) off. Then disconnect the recovery hose from the shoe.
FIGURE 6
A-10
INSTRUCTIONS FOR USE
MAINTENANCE ITEM
Clean Vacuum Shoe
Clean Track S16, L18 - 56091055
Daily Weekly
•
•
•
•
•
7
8
Yearly
•
FRONT
12/11