Publicidad
Idiomas disponibles
Idiomas disponibles
appear on the timer indicator (12)
Press the locking touch key
(6). The different power values
to which the hob can be limited
will appear and these can be
changed using the
(10) sensors.
once again press the locking touch
key
(6). The hob will be
limited to the chosen power value.
you must unplug the hob and plug it in
again after a few seconds. Thus you
will again be able to enter the power
limiting menu.
Every time the power level of a hotplate
calculate the total power the hob is
generating. If you have reached the
allow you to increase the power level of
that hotplate. The hob will beep and the
power indicator (3) will blink at the level
that cannot be exceeded. If you wish to
power of the other hotplates. Sometimes
it will not be enough to lower another
by a single level as this depends on the
power of each hotplate and the level it is
set at. It is possible that to raise the level
of a large hotplate that of several smaller
ones must be turned down.
If you use the quick switch-on at
maximum power function and the
said value is above the value set by
maximum possible level. The hob will
beep and the said power value will
blink twice on the indicator (3).
If due to an error one or several
appliance will be automatically discon-
nected after a set amount of time (see
table 1).
MAXIMUN
OPERATING TIME
0
1
2
3
4
5
(11) and
6
7
8
9
P
the glass surface temperature is not
dangerous for the user or an H if there
is a burn risk.
glass because they could scratch it.
from large pots and pans without
and pans over the glass and keep
the undersides of them clean and
in good condition.
bottom (see ''Technical Data Sheet''
supplied with the product).
0
8
8
To keep the appliance in good
5
4
products and implements once it has
cooled down. This will make the job
4
easier and avoid the build-up of dirt.
3
Never use harsh cleaning products or
2
steam-operated equipment.
2
1
Light dirt not stuck to the surface can
be cleaned using a damp cloth and a
gentle detergent or warm soapy water.
readjusts to level 9
(depending on model)
use a special cleaner for ceramic hot
plates and follow the instructions on
to being burned repeatedly can be
removed using a scraper with a blade.
Slight tinges of colour are caused by
pots and pans with dry grease residue
underneath or due to grease between
the glass and the pot during cooking.
These can be removed using a nickel
scourer with water or a special cleaner
sugar or food containing a lot of sugar
that have melted onto the surface
must be removed immediately using
a scraper.
Metallic sheens are caused by
dragging metal pots and pans over
the glass. These can be removed by
cleaning thoroughly using a special
although you may need to repeat the
cleaning process several times.
reserves the right to make changes to
its manuals that it deems necessary or
essential features.
EN
19
Publicidad
