Corradi MAGIKO Manual Del Usuario página 26

Magiko
MAINTENANCE
During all cleaning, maintenance, repair or adjustment operations on the product it is always required to disconnect the electrical power (in the
motorised model). It is advised to put a warning sign on the power supply main switch with the following indication: "Do not touch. Service
personnel at work". The use of ladders, scaffolding or other equipment is reserved to specialised personnel who must perform all operations in
compliance with current safety regulations, using the necessary PPE (Personal Protective Equipment).
Magiko is a unique product incorporating design concepts and materials featuring top level quality and durability.
To maintain the product fully functional over time, perform the cleaning and control actions as per the following table:
Components Cleaning and control actions
The internal part of the runners should be washed thoroughly with a jet of water, and if possible using a brush,
Runners removing all traces of dirt and/or salt deposits, as indicated in Figure 1.
Attention: Never lubricate the runners for any reason.
If you want to maintain the side exposed to the weather like new, wash it so as to prevent dust and smog deposits
on the canvas from becoming permanently fixed in the fabric through the action of the sun.
Canvas
To wash the canvas, spray water and mild soap on it, wait for a few minutes to make sure that the product has
time to act, then use a sponge to remove dirt without applying excessive pressure. Repeat if necessary and rinse
thoroughly.
The hardware is stainless steel. It must be rinsed with a jet of water to remove any dirt and/or salt deposits.
The appearance of micro-oxidation, more frequent in maritime environments subject to salt spray, does not affect
Hardware
the quality and durability of the product. Such oxidation is normal.
If you need to eliminate these oxidised spots you can use a steel wool or a brush with stainless steel bristles. The
protective chromium oxide film (self-passivation) will be restored naturally just through exposure to air, without
any intervention by the user.
Clean the painted aluminium profiles with a mild cloth dampened with water and mild soap.
Aluminium
ATTENTION: Do not use acid to clean aluminium parts.
Gaskets and silicon
Check the proper operation of the gaskets and reposition them correctly if they have shifted. Periodically check the
seals
status of silicon seals, and if there is any deterioration, contact your Authorised Retailer.
10 of 14 CORRADI SRL - USER MANUAL
1
for no reason whatsoever,
Method for cleaning the runners
In areas not exposed In areas exposed
to salty air and smog to salty air and smog
Once a year Once a month
2 or 3 times a year 2 or 3 times a year
Once a year Once a month
Once a year Once a month
Every 6 months Every 6 months
Attention:
Never lubricate,
the runners.
Rev.0_05.2018