Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE:
Congratulations on your purchase of a Homedics modulair™ product. Modulair™
is the first pneumatic compression system that allows you to customize your
experience by offering compression wraps and products for all parts of the body
all using the same controller module for complete flexibility. To start using your
modulair™ system, you'll need at least one modulair™ controller module
(Model SR-CMX10) and at least one modulair™ compression wrap.
1. Your modulair™ compression system uses a modulair
controller module (SRCMX10). To start, when opened, your
controller module may require charging. To charge the
battery, plug one end of the USB cord into the unit and plug
the other end into an adapter. Your controller module will
be fully charged after a maximum of 5 hours charge time,
and the charge will last up to 5 hours.
NOTE: This device only comes with a USB cord, not an
adapter. A USB charger will also charge the units. Do not
attempt to use a cord that is not a USB-type cord. Use only
with Listed/Certified ITE Power Supply. The units will not
operate when charging. Use a 5V/2A (or 5V/1A, slower)
charger, but not higher than 5V.
2. Your compression wrap can be used on either the left or right side.
3. Use the fastening tape to adjust the wrap so it's snug but comfortable. Do
not overtighten.
4. Connect your controller module to the compression wrap, sliding it into the
dock until it "clicks" into place. See image to the right.
5. Press the power button to turn on the unit. The display will illuminate to
confirm the unit is on.
6. Press the "MODE" button to select between the 4 massage modes. Press the
"HEAT" button to toggle between 3 levels of heat. Press the "INTENSITY"
button to adjust the intensity of the air compression.
7. The unit will turn off automatically after 15 minutes.
CAUTION: To avoid injury, always remain seated when using massager.
GB I 3
Publicidad
