Troy-Bilt 030247 Manual Del Operario página 5

Features and Controls
KNOWYOUR GENERATOR
Read this Operator's Manua[ and safety fumes before operating your generator.
__ Compare ths illustration with your generator to familiarize yourseff with the locations of various controls and
adjustments. Save ths manual for future reference,
Start Switch
Battery Float Charger
Rocker Switch
Circot Breaker
Fuel Tank
120/240 Volt AC,
30 Amp Receptacle
Circuit Breakers (AC)
Grounding Fastener
/ 120VokAC, 20Amp
Duplex Receptacles
Data Tag
Engine Rocker Switch
Recoil Starter
[ 20 Volt AC, 20 Amp, Duplex Receptacles -- Hay be
used to supply electrical power for the operation of
[ 20 Volt AC, 20 Amp, single phase, 60 Hz electrical lighting,
appliance, too[ and motor loads.
i 201240 Volt AC, 30 Amp Locking ReceptacJe -- Hay
be used to supply electrical power for the operation of
120 and/or 240VoltAC, 30 Amp, single phase, 60 Hz
electrical lighting, appliance, tool and motor loads.
Battery Float Charger -- Use battery float charger lack
to keep the starting battery charged and ready for use.
Air CJeaner -- Protects engine by filtering dust and
debris out of intake air.
Choke Lever -- Used when starting a cold engine.
Circuit Breakers (AC)--The 120VokAC_ 20A duplex
receptacles are provided with "push to reset" circuit
breakers to protect the generator against electrical overload.
DataTag -- Provides model rewsion and serial number of
generator. Please have these readily available when calling
for assistance.
Engine Rocker Switch -- Set this switch to "On" before
using recoil starter. Set switch to "Of[" to switch off engine.
Fuel Tank -- Capacity of seven (7) U.S. gallons.
Grounding Fastener -- Consult your local agency having
[urisdiction for grounding requirements in your area.
Oil Fill Cap -- Check and fill engine with oil here.
Recoil Starter -- Used to start the engine.
Rocker Switch Circuit Breaker --The 120/240VokAC,
30A locking receptacle is provided with a rocker switch circuit
breaker to protect the generator against electrical overload.
This switch also controls all receptacles.
Start Switch -- Push to start the engine.