Publicidad
Idiomas disponibles
Idiomas disponibles
GRASS
CATCHER
• The grass catcher may be hosed with
water, but must be dry when used.
• Check your grass catcher often for
damage
or deterioration.
Through
normal use it will wear.
If catcher
needs replacing,
replace only with a
manufacturer
approved
replacement
catcher.
Give the lawn mower model
number when ordering.
DRIVE WHEELS
Check front drive wheels each time
before you mow to be sure they move
freely. The wheels not turning freely
means trash, grass cuttings, etc. are in the
drive wheel area and must be cleaned to
free drive wheels.
If necessary to clean the drive wheels,
check both front wheels.
1. Remove
hubcaps,
hairpin cotters and
washers.
2.
Remove
wheels from wheel adjusters.
3.
Remove any trash or grass cuttings
from inside the dust cover, pinion and/
or drive wheel gear teeth.
4.
Put wheels back in place.
NOTE:
If after cleaning, the drive wheels
do not turn freely, contact your nearest
Sears or other qualified service center.
GEAR CASE
• To keep your drive system working
properly, the gear case and area
around the drive should be kept clean
and free of trash build-up.
Clean under
the drive cover twice a season.
• The gear case is filled with lubricant
to
the proper level at the factory.
The only
time the lubricant needs attention is if
service has been performed
on the
gear case.
• If lubricant
is required,
use only Texaco
Starplex
Premium
1 Grease,
Part No.
750369.
Do not substitute.
ENGINE
LUBRICATION
Use only high quality detergent
oil rated
with API service
classification
SF-SJ.
Select the oil's SAE viscosity
grade
according
to your expected
operating
temperature.
SAE VISCOSITY
GRADES
-20
.30
.20
.10
0
10
20
30
TEMPERATURE
RANGE ANTICIPATED
BEFORE NEXT OIL CHANGE
NOTE:
Although
multi-viscosity
oils
(5W30,
10W30 etc.) improve
starting
in
cold weather,
these multi-viscosity
oils
will result in increased oil consumption
when used above 32°F. Check your
engine oil level more frequently
to avoid
possible engine damage
from running
low on oil.
Change the oil after every 25 hours of
operation or at least once a year if the
lawn mower is not used for 25 hours in
one year.
Check the crankcase oil level before
starting the engine and after each five (5)
hours of continuous use. Tighten oil plug
securely each time you check the oil
level.
TO CHANGE ENGINE OIL
NOTE: Before tipping lawn mower to
drain oil, drain fuel tank by running
engine until fuel tank is empty.
1. Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
2. Remove engine oil cap; lay aside on a
clean surface.
3. Tip lawn mower on its side as shown
and drain oil into a suitable container.
Rock lawn mower back and forth to
remove any oil trapped inside of
engine.
4. Wipe off any spilled oil from lawn
mower or side of engine.
5. Fill engine with oil. See "ADD OIL" in
the Operation section of this manual.
6. Reconnect spark plug wire to spark
plug.
Container
AIR FILTER
Your engine will not run properly and may
be damaged
by using a dirty air filter.
Replace the air filter every 100 hours of
operation or every season, whichever
occurs first.
Service air cleaner more
often under dusty conditions.
Do not
wash air filter.
12
Publicidad
